HELE BOTTLE FOR 50 BALLONS - 13.6 L - 0.42 m3 + Sealer 50ml

Helium cylinder PLUS sealing gel 50ml - Up to 50 balloons - 13.6l - 0.42 m3

Disposable bottle of high-quality helium for balloons with a capacity of 13.6 L. The bottle allows you to fill the following number of balloons:

• Latex balloons (23 cm) - approx. 50 pcs.
• Latex balloons (28 cm) - approx. 25. pcs.
• Latex balloons (75 cm) - about 7 pcs.
• Foil balloons (46 cm - hearts) - approx. 25 pcs.
• Foil balloons (46 cm - round) - approx. 25 pcs.

The values given above apply only if the balloons are properly inflated (no helium loss during inflation) and no latex balloons are overinflated.

Remember! If you want to inflate other balloons, then carefully calculate the amount of helium needed. E.g. large film figure consumes as little as 0.04 cm3 - helium is enough for several balloons of this kind. In addition, the helium in latex balloons will only last for a longer period of time if the sealant included in the kit is used. With balloon sealer, decorations can float for several to even several days. Also remember that foil balloons will quietly float for several days without the need for sealant.

BE SURE TO CHECK OUT OUR OFFER FOIL BALLOONS AND LATEX BALLOONS!

Instructions for filling and sealing balloons

Balloons are best inflated 1-2 hours before the event.

1. Take the bottle out of the packaging.
2. Open the valve by turning the green knob counterclockwise.
3. Fill the balloon with literally a CRAP of sealing gel, then spread it over the inside of the balloon. Excessive amounts of gel can cause the balloon not to float under weight.
4. On the black end of the reducer pull the balloon so that the neck of the balloon fits tightly to the outlet end.
5. Tightly pressing the balloon, press the tip down - the filling will start się.
6. When the balloon reaches the right size, stop pressing - the filling will finish się. Remove the balloon tip from the reducer.
7. Tie a balloon.
8. Turn off the valve.

Record of helium cylinder handling

Helium remaining time in foil balloons: about 4 days.
Helium remaining time in latex balloons: about 5-7 hours.
Helium balloons are pumped at room temperature (18'C to 25'C) due to the thermal expansion of the gas (helium increases its volume at higher temperatures and decreases at lower temperatures).

Instructions for recycling a disposable helium cylinder

• Close the main valve,
• Unscrew and pull out the reducer used for filling,
• Open the main valve, making sure the cylinder is completely empty,
• Using a screwdriver and a hammer or other tool, lever up and remove the cap opposite the valve,
• Wait for the pressure remaining in the cylinder to escape,
• Cylinder is completely empty and ready for disposal to a container or scrap metal acceptor.